Err20 is one of the most information-rich faults on the NICE3000new: the sub-code pinpoints exactly which encoder signal failed. It is almost always an encoder, PG card or wiring issue.
Sub-Code Reference
- 1: no encoder signal during PM no-load tuning
- 3: motor line sequence reversed
- 4: no Z signal during PM identification
- 5: SIN_COS encoder signal broken
- 7: UVW encoder signal broken
- 9: excessive speed deviation
- 12: encoder A/B signal lost at start
- 13: encoder A/B signal lost during run
- 19: severe sine-cosine interference during run
- 55: severe interference or wrong C/D signals during tuning
Troubleshooting by Sub-Code
- 1, 4, 5, 7: check encoder signal wiring and the PG card.
- 3: swap any two of the motor U/V/W phases.
- 9: abnormal PM angle — re-tune; or speed-loop gain too low / integration time too large — increase gain or reduce integration time; verify U/V/W sequence.
- 12: check the brake opens; check A/B wiring; for rope-slip tests use F3-24.
- 13: check encoder wiring, look for interference or mid-run power interruption.
- 19, 55: inspect the encoder loop for interference and poor analog contact; check C/D signals are not swapped.
Pro Tip From the Field
If Err20 appears only when the car is moving and disappears at standstill, suspect a damaged encoder cable that opens under flexing — move the cable by hand while watching the signal.
Still stuck on this fault? Our engineers repair Monarch NICE3000 systems every day. Message us on WhatsApp (+86 139 8566 2489) — send a photo of your board or the fault display, and we will identify the part and guide you through the fix. Every board we sell is 100% run-tested with a 12-month warranty, MOQ 1 piece, and free remote parameter-setup support until your elevator runs.
Browse all codes in our free NICE3000 fault code library.

发表回复