Err22 means the NICE3000new controller sees a problem with the leveling (door-zone) signal. The elevator relies on these sensors for every stop, so this fault often leaves the car unable to run normally.
Sub-Codes
- 101: leveling signal stuck
- 102: leveling signal lost
- 103: in auto run, leveling position deviation too large
Troubleshooting
- Sub-codes 101, 102: check the leveling/door-zone sensors; check the vane is installed vertically and enters the sensor deep enough; check the leveling input points on the main control board.
- Sub-code 103: check the ropes for slipping — position deviation during auto run is a classic rope-slip symptom.
Pro Tip From the Field
A stuck leveling signal (101) is often a dirty or misaligned vane, while signal loss (102) is usually wiring. Clean the sensor face and check the vane gap before replacing sensors.
Still stuck on this fault? Our engineers repair Monarch NICE3000 systems every day. Message us on WhatsApp (+86 139 8566 2489) — send a photo of your board or the fault display, and we will identify the part and guide you through the fix. Every board we sell is 100% run-tested with a 12-month warranty, MOQ 1 piece, and free remote parameter-setup support until your elevator runs.
Browse all codes in our free NICE3000 fault code library.

发表回复