Monarch NICE3000new Err20 — Speed Feedback Error: Complete Sub-Code Table

Err20 is one of the most information-rich faults on the NICE3000new: the sub-code pinpoints exactly which encoder signal failed. It is almost always an encoder, PG card or wiring issue.

Sub-Code Reference

  • 1: no encoder signal during PM no-load tuning
  • 3: motor line sequence reversed
  • 4: no Z signal during PM identification
  • 5: SIN_COS encoder signal broken
  • 7: UVW encoder signal broken
  • 9: excessive speed deviation
  • 12: encoder A/B signal lost at start
  • 13: encoder A/B signal lost during run
  • 19: severe sine-cosine interference during run
  • 55: severe interference or wrong C/D signals during tuning

Troubleshooting by Sub-Code

  • 1, 4, 5, 7: check encoder signal wiring and the PG card.
  • 3: swap any two of the motor U/V/W phases.
  • 9: abnormal PM angle — re-tune; or speed-loop gain too low / integration time too large — increase gain or reduce integration time; verify U/V/W sequence.
  • 12: check the brake opens; check A/B wiring; for rope-slip tests use F3-24.
  • 13: check encoder wiring, look for interference or mid-run power interruption.
  • 19, 55: inspect the encoder loop for interference and poor analog contact; check C/D signals are not swapped.

Pro Tip From the Field

If Err20 appears only when the car is moving and disappears at standstill, suspect a damaged encoder cable that opens under flexing — move the cable by hand while watching the signal.


Still stuck on this fault? Our engineers repair Monarch NICE3000 systems every day. Message us on WhatsApp (+86 139 8566 2489) — send a photo of your board or the fault display, and we will identify the part and guide you through the fix. Every board we sell is 100% run-tested with a 12-month warranty, MOQ 1 piece, and free remote parameter-setup support until your elevator runs.

Browse all codes in our free NICE3000 fault code library.


评论

发表回复

您的邮箱地址不会被公开。 必填项已用 * 标注